Tuesday, January 25, 2011

Temperature Switch Project




Temperature Switch Project
This project will provide you an understanding of the use of germanium diode and how it works compared to the more common silicon diode. It works on the principle that as the temperature surrounding the germanium diode increases, the back resistance decreases sharply.
At room temperature, the germanium diode D1 has a typical back resistance of 10K ohm. At this value, the base of transistor Q1 is turned ON, causing transistor Q2 to turn ON as well. When this happens, the base of transistor Q3 is kept to ground causing it to turn OFF hence the buzzer is OFF.
When the temperature of the surrounding increases, the back resistance of the germanium diode D1 decreases sharply causing the base of transistor Q1 to pull down to near ground potential. This cause the transistors Q1 and Q2 to turn OFF. Transistor Q3 is now forward bias through resistor R2 and diode D2. This caused the buzzer to turn ON indicating that the ambient temperature has risen. The sensitivity of the circuit can be adjusted by adjusting variable resistor VR1 and subjecting diode D1 to a temperature that will trigger the buzzer.



Schematic Diagram
The schematic of the project is as shown below.





Parts List




ref:  electronics-project-design.com/temperatureswitch.html

0 comments:

Post a Comment